1在清洗過程中，要注意很多地方，禁止導電液體（如水）從超聲波控制柜頂部的進氣口進入。否則會對清洗機的電路系統造成嚴重損壞。

During the cleaning process, it is important to pay attention to many areas and prohibit conductive liquids (such as water) from entering the air inlet at the top of the ultrasonic control cabinet. Otherwise, it will cause serious damage to the circuit system of the cleaning machine.

2不使用時，保持機器清潔并關閉電源。

When not in use, keep the machine clean and turn off the power.

3我們的機器不是耐碰撞的產品，所以在使用時要避免碰撞或劇烈振動。

Our machine is not a collision resistant product, so it is important to avoid collisions or severe vibrations during use.

4我們應該讓機器遠離高溫熱源。

We should keep the machine away from high temperature heat sources.

5同時，我們應該避免把機器放在潮濕的環境中。

At the same time, we should avoid placing the machine in a damp environment.

6機器的連續工作時間不得超過4小時。例如，關閉超聲波按鈕，讓散熱器風扇繼續工作。當超聲波清洗未開始時，應連續冷卻超聲波控制柜2-3分鐘。

The continuous working time of the 6 machines shall not exceed 4 hours. For example, turn off the ultrasonic button to allow the radiator fan to continue working. When ultrasonic cleaning has not started, the ultrasonic control cabinet should be continuously cooled for 2-3 minutes.

7對于長時間運行的清洗機，關機前應將電源旋鈕調0，工作3-6分鐘后關閉風扇，使電源內部熱量散失。

For a cleaning machine that has been running for a long time, the power knob should be turned to 0 before shutting down. After working for 3-6 minutes, the fan should be turned off to dissipate internal heat from the power supply.

8清洗液應及時沉淀、過濾或更換，確保清洗效果。

8. The cleaning solution should be precipitated, filtered or replaced in a timely manner to ensure the cleaning effect.